Quadro Quadro4x Installation Guide download pdf (Page 22)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

Configuring the E1/T1 Settings

The QuadroE1/T1 can be connected to a PBX or to the PSTN via E1/T1 lines, using E1/T1

CAS/CCS signaling. The QuadroE1/T1 may be connected to act as a User (if connected to

directly to the PSTN) or as a Network (if connected to a PBX).

Further, you are required to enter the E1/T1 settings your PSTN provider requires regarding

framing, clocking, signaling used and so on. All these settings must be entered on the man-

agement page Trunk Settings that is displayed when you select E1/T1 Settings from the

Telephony menu:

The Trunk Settings page is used to configure the E1/T1 trunk and timeslots settings. The

table lists the available E1/T1 trunks of Quadro and their settings (Trunk name, E1/T1 mode,

interface and signaling type). Clicking on the trunk will open its Signaling Settings page

(Trunk CAS Signaling Settings or the Trunk CCS Signaling Settings page depending on the

selected signaling type). Selecting the corresponding trunk's checkbox and pressing Edit will

open the Trunk - Edit Entry page. The E1/T1 Stats link is displayed for every active Quadro

trunk and leads to the page where the E1/T1 trunk and the traffic statistics can be viewed.

QuadroE1/T1; (SW Version 2.4.x) 21

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 40 41

No comments

Quadro Quadro4x Installation Guide Page 22