Quadro Quadro4x Installation Guide download pdf (Page 28)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

Setting up Call Routing

The Call Routing service allows you to specify the communication structure between all in-

volved devices by developing a dialing plan and setting the call routing paths accordingly.

For the Quadro extension users, the call procedure should be simple and familiar for all

kinds of calls (internal, IP, PSTN or IP-PSTN).

The possibilities Call Routing offers are numerous. The following configuration just a single

example used to explain setup of the QuadroE1/T1 as a gateway:

In this example, the QuadroE1/T1 is connected within a protected Private Data Network built

of two other Quadro devices (-2x and -4x) where 6 extensions are connected. Each exten-

sion will be configured such that they all shall reach each other and the PSTN. The exten-

sions also shall be reached by calls from the PSTN.

Your PSTN Service Provider supplies you with a set of PSTN telephone numbers for your

E1/T1 line. If you want to assign these numbers to the phones connected to the Quadro2x

and Quadro4x within your Private Data Network, you have to create a dial plan to define Call

Routing paths on the QuadroE1/T1 and on each of the other Quadro devices.

To illustrate the dial plan with an example, we will assume, you have the phone number set

854603-30 to 854603-59 and you assigned the numbers as follows:

Quadro 2x (IP: 10.20.30.10) Quadro4x (IP: 10.20.30.20) QuadroE1/T1 (IP: 10.20.30.30)

Auto Attendant 854603-30 Auto Attendant 854603-40 Extension 1 854603-50

Extension 1 854603-31 Extension 1 854603-41

Extension 2 854603-32 Extension 2 854603-42

Extension 3 854603-43

Extension 4 854603-44

Auto Attendant:

All numbers of the numbers set,

that are not assigned to an ex-

tension are caught here

All unassigned numbers of the phone number set will lead to the Auto Attendant of

QuadroE1/T where a message may inform the callers that the dialed number does not exist.

QuadroE1/T1; (SW Version 2.4.x) 27

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 40 41

No comments

Quadro Quadro4x Installation Guide Page 28