Quadro Quadro4x Installation Guide download pdf (Page 24)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

Signaling Type CCS

If you selected CCS as your Signaling Type, using the Trunk link will take you to the page

shown above. Here you can specify the signaling settings in more detail. Further, this page

allows selection of the timeslots for signaling data and voice.

The D Channel Timeslot For Transmit/Receive drop down list offers all available timeslots

to be selected for signaling data transmit/receive.

The Non Automat checkbox switches to non-automatic channel searching and enables the

TEI Address requires the TEI number (digit values from 0 to 63) for connection establish-

ment between the CO/PSTN and the E1/T1 client.

In the Network Mode (PBX connected) you need to specify the same TEI address on both

sides (Quadro and PBX), if the Non Automat mode is selected. If the Automat mode is se-

lected the user on the PBX side may set any mode related to TEI assignment in the PBX

configuration.

In the User Mode (CO/PSTN connected) the TEI assignment depends on the CO/PSTN set-

tings. So you have to enter the values you've got from your PSTN provider.

Excessive Ack. Delay T200 and requires the period in milliseconds (digit values from 500

to 9999) between two status checks. Idle Timer T203 requires the period in milliseconds

(digit values from 1000 to 99999) for the E1/T1 client idle timeout. These settings are both

provided by the CO.

Route Incoming call to offers Attendant, Routing, Routing with inbound destination

number and 21 (Quadro's FXS extension) to be selected.

Routing will request the caller to pass the authentication (if enabled) and will invite the caller

to dial the destination number to connect the user within the Quadro Network.

Routing with inbound destination number will automatically use the initially dialed num-

ber to connect to the destination without any additional dialing.

The value for Switch Type depends on the CO when acting in the User mode and the pri-

vate PBX capabilities when acting in the Network mode.

The link B Channels leads to the Signaling Type CCS - B Channel Settings page (see

below) where available timeslots may be enabled/disabled for the voice transfer. The Force

Update option can be optionally used to apply new settings immediately. This will force the

timeslot(s) to be restarted and any active connection on the selected timeslot(s) will be inter-

rupted. Edit will display another page, where the signaling settings for the selected timeslots

may be specified in detail.

Attention: A timeslot can be used either for voice or signaling data transfer. The configura-

tion prevents the selection of a timeslot from the B channel list if it has already been selected

from the D Channel receive/transmit drop down list.

QuadroE1/T1; (SW Version 2.4.x) 23

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 40 41

No comments

Quadro Quadro4x Installation Guide Page 24