Quadro Quadro6L Installation Guide download pdf (Page 22)

Quadro6L/4L/2x2 Manual I: Installation Guide Step 2: Configuring the Quadro

Quadro6L/4L/2x2; (SW Version 5.3.x and higher) 22

DHCP Settings for the LAN Interface

If the DHCP server is enabled, the Quadro will automatically assign dynamic IP addresses

to the stations connected to its LAN port.

If you didn’t change the default LAN IP address of the Quadro, you also may leave the de-

fault values for the IP Address Range. Make sure your connected LAN devices belong to

the same network as the LAN port of your Quadro.

Please Note: Make sure there is only one DHCP server on the LAN, otherwise, unpredict-

able network behavior can occur.

Fig. l- 19: DHCP Settings for the LAN Interface page

Click on Next to display the

Regional Settings

Regional Settings page.

If your Quadro is located outside of the United States, it is important to properly configure

your line connections to the PSTN in your location.

Fig. l- 20: Regional Settings page

Proper configuration of Regional Settings is important for the functionality of the voice

subsystem. The Regional Settings determine the proper telephony parameters on the LINE

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 56 57

No comments

Quadro Quadro6L Installation Guide Page 22