Quadro Quadro6L Installation Guide download pdf (Page 9)

Quadro6L/4L/2x2 Manual I: Installation Guide Hardware Overview

Quadro6L/4L/2x2; (SW Version 5.3.x and higher) 9

5. RJ45 socket to attach the Internet Uplink (WAN) via an Ethernet CAT 5 cable.

This port may also be used to connect IP phones to the Quadro. The default con-

figuration settings assume that IP phones are attached to this, rather than the

LAN port.

6. PHONE sockets with RJ11 connectors enable connectivity of regular analog tel-

ephones. These are FXS (Foreign Exchange Station) analog ports.

Quadro6L/4L/2x2’s Front Panel LEDs

Fig. l- 3: Quadro4L's Front Panel LEDs

BUSY, green

Status of CPU

off: No power

on or blinking: Normal activity

INFO/FAULT,

yellow/red/green

System information

on (yellow):

device is booting

on (red):

error or system is booting

on (green):

system is operational

blinking (yellow/green):

event occurred, details specified in

the System Event section of the Man-

agement interface

blinking (red/green):

system unusable

blinking (red/yellow):

emergency firmware is needed

blinking (red/green/red/yellow):

firmware update

For Quadro 6L- Green

LED for FXO Lines 1– 6

on or blinking: line in use

off: line not in use

For Qudaro4L-

Green LED

for FXO Lines 1 – 4

on or blinking: line in use

off: line not in use

For Qudaro2x2- Green

LED for FXO Lines 1 – 2

on or blinking: line in use

off: line not in use

EXT 1 – Green LED

(available only for Qua-

dro4L and Quadro2x2)

on or blinking: line in use

off: line not in use

EXT 2 – Green LED

(available only for Qua-

dro4L and Quadro2x2)

on or blinking: line in use

off: line not in use

LED Indication during a firmware update

A firmware update is indicated by the yellow/red/green Info/Fault LED. It will blink

red/green for about five minutes while the firmware is updated. The Quadro will then re-

boot automatically showing the boot LED sequence.

LED Indication during a boot sequence

A boot sequence is indicated as follows: The yellow/red/green Info/Fault LED will glow red

for a few seconds, then turn to yellow for another four or five minutes while the green Busy

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 56 57

Comments to this Manuals

No comments

Quadro Quadro6L Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Premise Branch Exchange (PBX) systems Quadro Quadro6L