Quadro Quadro6L Installation Guide download pdf (Page 32)

Quadro6L/4L/2x2 Manual I: Installation Guide Step 2: Configuring the Quadro

Quadro6L/4L/2x2; (SW Version 5.3.x and higher) 32

Step 2-A: Using IP Lines

Before starting the IP Lines configuration, the appropriate IP phone should be connected to

the Quadro either through its WAN or LAN port. If the phones are placed on the Quadro

WAN, which the default configuration assumes, please ensure that the Connect IP phones

from WAN side checkbox is enabled on the Line Settings page (see Fig. l- 32).

The Quadro6L/4L/2x2 provides two options for configuring IP phones:

• The Plug-and-Play option is available for supported SIP phones only. The list of

these phones is given

below. The Plug-and-Play option does not require any

specific configuration except that the Enable PnP for IP lines checkbox should

be enabled on the Line Settings page (see Fig. l- 32).

• The Auto-Configuration option is available for tested and supported SIP

phones. The list of tested SIP phones is given

below. The Auto-Configuration

option (described in detail below) requires specifying some basic parameters on

the Quadro and restarting the phone.

Please Note: With the both options, IP phones download their configuration from the Qua-

dro’s TFTP server. Therefore, if the phones obtain their network parameters from a DHCP

server other than the Quadro’s built-in DHCP server, please ensure that either the server

does not provide the “TFTP server” parameter or the parameter is set to the Quadro’s LAN

or WAN IP address depending on the location of IP phones.

When using the automatic-configuration option, each IP line should be configured indivi-

dually from the Telephony menu, Line Settings page.

Open from the Telephony menu and choose Line Settings page. The IP Line Settings

page is displayed.

Fig. l- 32: Line Settings page

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 56 57

No comments

Quadro Quadro6L Installation Guide Page 32