Quadro SW-Version 4.1.x User's Guide download pdf (Page 38)

Quadro Manual III: Extension User's Guide Extension User’s Menus

Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 38

Hot Line Settings

Hot Line Settings are used to set a destination that should be automatically dialed in case of no action for a predefined period after lifting the

handset. This user-configurable service is commonly used for emergency calls.

The Hot Line Settings page offers of the following input options:

Enable Hot Line Service enables the Hot Line Service and all

components below.

Timeout is used to select the inactivity timeout before the defined

number will be dialed automatically.

Call Type lists the available call types:

• PBX - local calls between Quadro extensions and the Auto

Attendant

• SIP – calls through a SIP server

• Auto – destination (independent on whether it is a PBX

number, a SIP address or a PSTN number) will be reached

through Routing.

Depending on the Call Type selection, a destination extension

number, a SIP address (see chapter

Entering a SIP Addresses

correctly

), or a PSTN number should be inserted into the text field

Called Address. If the defined caller address is not corresponding

to these requirements, an error message, "Caller address is

incorrect", will appear and prevent saving the incorrect data. The

PSTN number length depends on the area code and the phone

number.

Fig. 3-37 Basic Services - Hotline Settings page

Logout

This option is used to close the session between the user PC and Quadro and to leave the Quadro Web Management or enter into the management

with another login. By selecting the Web Management link, the startup page will be displayed and the user will need to login again.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43

No comments

Quadro SW-Version 4.1.x User's Guide Page 38