Quadro Quadro4x Installation Guide download pdf (Page 47)

Quadro Manual I: Installation Guide Appendix: PC DHCP Settings

Appendix: PC DHCP Settings

The Quadro has a DHCP server for the LAN side devices that provides DHCP IP ad-

dresses to devices connected to the LAN either directly or through an Ethernet hub or

switch. This appendix describes how to configure Windows PCs for DHCP. The PC used to

access the Quadro must meet the following conditions:

• TCP/IP network protocol has to be installed.

• DHCP has to be activated in order to request the IP address automatically.

Please Note: If your PC is already configured for DHCP and connected directly to the

Quadro, then simply power it on and verify the LAN LED is lit. If LED is off, check the cable

connections.

Follow the instructions below to install TCP/IP and enable DHCP functionality:

TCP/IP and DHCP under Windows 2000/Windows XP

Windows 2000 and Windows XP PCs with Ethernet cards or adapters normally are config-

ured with a TCP/IP network connection by default. Nothing in addition is required. To en-

able the DHCPs functionality, you may have to modify the properties of TCP/IP:

1. Click the Start button. Choose Settings, then

Control Panel.

2. Double-click on the Network Connection icon

to open the corresponding window. Select Lo-

cal Area Connection with the right mouse

button and select Properties.

3. Highlight Internet Protocol (TCP/IP) under

General tab and click Properties. The cor-

responding window will be displayed.

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 61 62

No comments

Quadro Quadro4x Installation Guide Page 47