Quadro Quadro4x Installation Guide download pdf (Page 52)

Quadro Manual I: Installation Guide Appendix: Configuring NAT Traversal

Fig. I-41: NAT Traversal Settings – General Setting

Go to SIP Parameters page.

Fig. I-42: NAT Traversal Settings - SIP Parameters

Select Use Manual NAT Traversal and enter the WAN IP address of the router into the

Mapped Host text field. For Mapped Port, enter the router's corresponding port num-

ber, in this case 5060. Save the entries.

• Go to the RTP Parameters page and select Use Manual NAT Traversal.

Fig. I-43: NAT Traversal Settings - RTP Parameters

• Enter the WAN IP address of the router into the Mapped Host text field. Set the

Mapped RTP/RTCP Port Range according to the values specified on the router, in this

case to 6000 (Min) and 6099 (Max), respectively. Click the Save button to save the

contents.

The Quadro will activate the settings and register the extensions on the Epygi SIP Server

after a few minutes. You can verify the settings from the main Quadro Management menu

under Status in the SIP Registration Status section.

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 52

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

No comments

Quadro Quadro4x Installation Guide Page 52