Quadro Manual I: Installation Guide Requirements
Requirements
• One 120/240 VAC power outlet in close proximity to the Quadro.
• One RJ45 Ethernet 10/100 broadband Internet connection.
• At least one RJ11 telephone connection is recommended to connect the Quadro to
the PSTN network (all Quadro IP PBXs with FXO ports). For ISDN Quadros an RJ45
CAT 5 cable is needed to connect Quadro to ISDN.
• At least one off-the-shelf analog phone with an RJ11 telephone cable.
• One CAT 5 Ethernet cable with an RJ45 connector to connect to the Quadro LAN port.
• One PC with a 10/100 Mbps Ethernet card or adapter installed.
• TCP/IP network protocol installed on each PC.
• For optimal results, Internet Explorer 5.5 or higher, or Netscape Navigator 4.7 or
higher are recommended.
Please Note: All Quadro IP PBXs are shipped with one RJ11 cable and one straight RJ45
CAT 5 cable. If the LAN connector of the Quadro connects to a hub or switch, a crossover
cable may be required.
Other cables are added according to the different connectivity requirements of the Quadro
IP PBX types.
Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 8
Comments to this Manuals