Quadro Quadro4x Installation Guide download pdf (Page 22)

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro

DHCP Settings for the LAN Interface

If the DHCP server is enabled, the Quadro will automatically assign dynamic IP addresses

to the stations connected to its LAN port.

If you didn’t change the default LAN IP address of the Quadro, you also may leave the de-

fault values for the IP Address Range. Make sure your connected LAN devices belong to

the same network as the LAN port of your Quadro.

Please Note: Make sure there is only one DHCP server on the LAN, otherwise, unpredict-

able network behavior can occur.

Fig. I-16: DHCP Settings for the LAN Interface page

Click on Next to display the Regional Settings page.

Regional Settings

If your Quadro is located outside of the United States, it is important to properly configure

your line connections to the PSTN in your location.

Fig. I-17: Regional Settings page

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

No comments

Quadro Quadro4x Installation Guide Page 22