Quadro Quadro16xi Installation Guide download pdf (Page 37)

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro

In both cases, with this selection, Quadro sets the TEI to manually mode assigning the

default value of 0. If needed, that value can be changed later in the Advanced Set-

tings page of ISDN Wizard.

• PTMP (Point to Multi Point)

In case of connection to the CO (User interface type is selected on the Quadro)

choose this option if there can be other devices connected to the same ISDN trunk

from CO except the Quadro.

In case of connection to PBX (Network interface type is selected on the Quadro)

choose this option if there can be other devices connected to the same ISDN trunk

from Quadro except for the PBX.

In both cases, with this selection Quadro sets the TEI to automatic mode.

Please Note: Consult with your CO operator or network administrator before configuring

the ISDN connection type.

Fig. II-33: ISDN Wizard – ISDN Settings

The ISDN Wizard - Page 2 content is dependent on the connection type selected on the

previous page of ISDN Wizard:

The next page is ISDN Wizard – MSN Settings page which is used to turn on the MSN

configuration. It is recommended to enable the MSN when there are multiple ISDN devices

connected to the same ISDN bus. If the MSN is enabled on this page, the next page will

require the MSN table configuration.

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.1.x) 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 56 57

No comments

Quadro Quadro16xi Installation Guide Page 37