Quadro Quadro16xi Installation Guide download pdf (Page 41)

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.1.x) 41

The Called Party Type of Number drop down list allows you to select the type identifying

the subaddress of the called party of the call.

The Called Party Numbering Plan and Calling Party Numbering Plan drop down lists

correspondingly indicate the numbering plan of the called party's and calling party's num-

ber.

The Incoming Called Digits Size text field indicates the number of received digits (in a

range from 0 to 255) required to establish a call. When this field has a “0” value, the system

uses either the timeout defined in the T302 field or the Sending Complete Information

element messages to establish a call. Independent on the value in this field, Sending

Complete Information element and the pound sign always result in call establishment.

The Generate Progress tone on IP checkbox selection will generate the progress tone to

IP.

When Generate Progress Tone to PSTN/PBX checkbox is selected, Quadro generates

ring tones to callers during ISDN call dialing. This feature is mainly applicable to 2-stage di-

aling mode.

Enable CLIR Service checkbox selection enables Calling Line Identification Restriction

(CLIR) service which displays the incoming caller ID only if Presentation Indication is al-

lowed on the remote side. Otherwise, if CLIR service is disabled, caller ID will be uncondi-

tionally displayed.

When the Alternative Disconnection Mode checkbox is not selected, Quadro will discon-

nect the call as soon as the disconnect message has been received from the peer. When

the checkbox is selected, Quadro’s user may hear a busy tone when peer has been dis-

connected.

The Override CLID with P-Asserted-Identity checkbox selection enables SIP P-Asserted-

Identity support. For the calls from SIP to ISDN if Invite SIP message contains a P-

Asserted-Identity, then the CallerID on ISDN is sent with the value from the " P-Asserted-

Identity" field, otherwise the CallerID on ISDN is sent with the value from the "From" field.

For the calls from ISDN to SIP if the incoming CallerID from the ISDN network contains a

restricted flag then the "P-Asserted-Identity" field in the Invite SIP message contains the re-

stricted CallerID and the "From" field contains "anonymous".

When the Send Calling Party Subaddress checkbox is selected, Quadro will send the ex-

tension number as subaddress and the value defined in the Default outgoing Caller ID

field as caller ID on the outgoing call. When this checkbox is disabled, no subaddress in-

formation will be sent and the caller ID will be defined according to the selection of the Use

Default Outgoing Caller ID checkbox (see above). Caller ID information, along with the

Subaddress, can be displayed on the phone display depending on the phone and PBX set-

tings and capabilities.

The B1 Channel and B2 Channel checkboxes enables/disables timeslots for voice trans-

fer. Disabling the timeslot will prevent both incoming and outgoing calls.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 56 57

No comments

Quadro Quadro16xi Installation Guide Page 41