Quadro Manual II: Administrator's Guide Quadro's Graphical Interface
Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 5
Quadro’s Graphical Interface
Administrator’s Main Page
When the administrator logs in, the Quadro Management page is displayed with a table of active calls (including information about call peers, call
duration and start time) at the startup. The button Terminate next to each active call is used to terminate the corresponding call. The number of total
active calls is displayed above the table.
Fig. II-1: Quadro4x Management
Here the administrator may access the following settings and perform the actions:
By clicking on System, Users, Telephony, Internet Uplink or Network the administrator may access the following settings in each respective
category and perform actions specific to each category.
The Install Checklist option in the Main Menu opens a page that lists the most useful actions and the corresponding hyperlinks for the Quadro’s
initial setup and configuration procedure. From this page you can be linked to the appropriate pages where the corresponding configuration can be
done. Here, you can also save your progress of Quadro’s setup by selecting the corresponding action’s checkbox and pressing Save.
System Menu
• System Configuration Wizard
• Internet Configuration Wizard
• System Security Management
• Status
• IP Routing Configuration
• Configuration Management
• Events
• Time/Date Settings
• Mail Settings
• SMS Settings
• Firmware Update
• Networking Tools
• SNMP Settings
• Diagnostics
• Automatic Provisioning
• Features
• Upload Language Pack
• User Rights Management
Telephony Menu
• Call Statistics
• SIP Settings
• RTP Settings
• NAT Traversal Settings
• Line Settings
• FXO Settings
• ISDN Settings
• External PSTN Gateways
• Gain Control
• SIP Tunnel Settings
• Call Routing
• VoIP Carrier Wizard
• RADIUS Client Settings
• Voice Mail Common Settings
• Dial Plan Settings
• 3PCC Settings
• RTP Streaming Channels
• Call Recording Settings
Internet Uplink Menu
• PPP/ PPTP Settings
• VPN Configuration
• Dynamic DNS Settings
• Firewall and NAT
• Filtering Rules
• IDS Log
Users Menu
• Extensions Management
• Receptionist Management
• Extensions Directory
• Authorized Phones Database
Network Menu
• DNS Settings
• DNS Server Settings
• DHCP Settings for the LAN
Interface
Registration Form
(in menu tree only)
Logout
The functional button Renew Wan IP Address appears on the administrator’s main Quadro Management page if the Quadro device acts as a
DHCP client. The Renew WAN IP Address button is used to obtain a new WAN IP address in case, e.g., the Quadro moves to another network.
The functional button Establish Your Internet Connection Now respectively Terminate Your Internet Connection Now occurs on the Quadro
Management page if PPPoE is used as WAN interface protocol.
The link Please Check Your Pending Events will be displayed on the administrator Main Menu page if new system events exist. The link leads to
the Events page that can be also accessed from the System menu.
The list of Users currently logged into the system is seen in the lower right corner of the Administrator's Main Menu. Information about IP address
user accessed Quadro GUI from, the username user is logged in and the time until the next automatically logout is provided herein. The current
version of the Quadro's firmware and of its boot loader is also available here. The idle session timeout is set to 20 minutes. If no action is performed
during that time, user will be automatically moved to the Login page and will be requested to login again.
Comments to this Manuals