Quadro Quadro16xi Installation Guide download pdf (Page 18)

Quadro Manual I: Installation Guide Step 1: Installing the Quadro

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.1.x) 18

• Verify the product package contents are complete. Refer to the contents sheet included

in the packaging to determine if all the items were shipped in the box.

• Before you connect the hardware, make sure that all devices are powered off.

• Connect telephones to the PHONE ports on the Quadro’s rear panel. You may connect

as many phones as there PHONE sockets available. PHONE socket 1 must be con-

nected to a telephone to enable lifeline support functionality.

• Connect at least one of Quadro's LINE (FXO) ports to the telephone service from the

PSTN. The Quadro2x offers connectivity of one line, Quadro4x offers two lines, and the

Quadro16x offers four lines. If you use a Quadro4xi, connect the Quadro's ISDN port to

the digital telephone service (or to an ISDN port of a PBX).

Please Note: If your Internet connection is a DSL modem, you may need to use a mi-

cro filter between the FXO LINE port and the phone line. Micro filters are typically pro-

vided by your ISP but are also available at most computer stores. If a micro filter is al-

ready installed, simply connect the RJ11 from the existing phone to the Quadro FXO

port leaving the micro filter connection as is.

• Connect the Ethernet port on your PC via a straight CAT 5 cable with an RJ45 connec-

tor to the LAN socket of the Quadro. If a hub or switch is connected between the

Quadro and your PC, use a crossover cable from the LAN interface of the Quadro to

the hub/switch.

• Connect the WAN port of the Quadro to the Internet service via a cable or DSL modem.

• Power up the DSL or Cable modem first.

• Connect the power adapter to the POWER port on the Quadro’s rear panel and plug

the power adapter into a power outlet. Only use the original Quadro power adapter and

plug it into a power strip with surge protection or to a UPS if available.

The red LED (Fault) will glow for several seconds followed by the yellow LED (Info),

which will glow for several minutes. When Info LED is off, the Quadro is operational.

• Power up any hub or switch followed by any PC and other devices on the LAN side.

Please Note: The PC must be configured for DHCP to receive an IP address directly

from the Quadro. Refer to Appendix: PC DHCP Settings

for instructions on setting up a

PC for DHCP operation.

• Check the LEDs: The green Busy LED must glow continuously. The green LAN and

WAN LEDs will blink when cables are connected to these ports and all devices are

powered up. If the green LAN and WAN LEDs do not blink, verify cabling and ensure

that all devices are powered up.

Please Note: CAT 5 cables can be faulty without any visual indication. The LAN and

WAN LEDs verify that the Ethernet connection is established between the end points. If

these LEDs are not illuminated, there is a connection problem between the Quadro and

the other device. Some modems, hubs, switches and routers will require the use of

crossover cables.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

No comments

Quadro Quadro16xi Installation Guide Page 18