Quadro SW-Version 4.1.x User's Guide download pdf (Page 29)

Quadro Manual III: Extension User's Guide Extension User’s Menus

Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 29

Address requires a SIP address (see chapter Entering a

SIP Addresses correctly

), an extension or a PSTN

number, for whom supplementary services should be

applied. If the address already exists in the table,

selecting Save will give the error “Caller address already

exists”. A wildcard is allowed in this field (see chapter

Entering a SIP Addresses correctly). Entering “*” as PBX

or PSTN addresses will apply configuration of

supplementary services to all extensions or PSTN users.

Two digits should be inserted in the Address text field for

the PBX call type. The PSTN number length depends on

the area code and phone number.

Fig.III-20 Caller ID Based Services – Add Entry page

When clicking on the Address in the Caller ID Based

Services table, the caller ID based services configuration

pages for the corresponding extension will be displayed.

The Caller ID Based Services for Address page

consists of two frames. In the left frame all caller ID

based services are listed. Clicking on the corresponding

caller ID based service, its settings will be displayed in

the right frame.

Please Note: Remember to save changes before moving

between the caller ID based services configuration

pages.

Fig. III-21 Caller ID Based Services for Address page

Below are the instructions to configure each caller ID based service available to the user.

To Configure Caller ID Based Services

1. Press the Add button on the Caller ID Based Services page. The Caller ID Based Services - Add Entry page, where new addresses can be

defined, will appear in the browser window.

2. Define an optional Description of the address.

3. Select the call type from the Call Type drop down list.

4. Enter the SIP address, extension or PSTN number (dependant on the chosen call type) in the Address text field according to the entering rules.

5. To add an address to the Caller ID Based Services table, click Save.

6. Click on the newly created Address in the Caller ID Based Services table to open the Caller ID Based Services for Address page.

7. From the left frame, choose a Caller ID Based Services. From the right frame, enable, configure and adjust the corresponding service. Do this

for each service. Remember to Save the configurations each time moving between the Caller ID Based Services configuration pages.

To Edit Caller ID Based Services

1. Select the checkbox of the corresponding address that has to be edited in the Caller ID Based Services table. The Caller ID Based Services -

Edit Entry page will appear in the browser window.

2. Change the Description of the address, if needed.

3. Change the Call Type and the Address defined in the corresponding fields.

4. Save changes.

5. If the reconfiguration of Caller ID Based Services is needed, click on the corresponding Address in the Caller ID Based Services table to

open the Caller ID Based Services for Address page.

6. From the left frame, choose a Caller ID Based Services. From the right frame, change the corresponding service settings, if required.

Remember to Save the configurations each time moving between the Caller ID Based Services configuration pages.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 42 43

Comments to this Manuals

No comments

Quadro SW-Version 4.1.x User's Guide Page 29

Comments to this Manuals