Quadro SW-Version 4.1.x User's Guide download pdf (Page 36)

Quadro Manual III: Extension User's Guide Extension User’s Menus

Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 36

Intercom

Intercom service is used to call an extension by forcing it to go off-hook and opening two-way communication. The service is particularly used for

announcements addressed to an extension. When the call comes in to the extension which has an Intercom service enabled, called extension will

automatically go off-hook (the phone speaker automatically becomes activated) and the caller will be able to make his announcement.

Please Note: Intercom service requires called extension to use one of the following SIP or analog phones which are able to automatically go off-

hook:

• SNOM 320 (SIP phone)

• SNOM 360 (SIP phone)

• Aastra 480i (SIP phone)

• Aastra 9133i (SIP phone)

• Aastra 9112i (SIP phone)

• Aastra 480e (analog phone)

The Enable Service checkbox selection activates the

Intercom service on the current extension.

Attention: Intercom will not work if the called extension

is in call. If this service is enabled along with Many

Extension Ringing, Call Hunting or Forwarding services,

Intercom will not take effect and other high priority

services will be primary.

Fig. III-33 No Answer Call Forwarding page

Basic Services

The Basic Services page allows you to configure the basic telephony features of Quadro, such as Call Waiting, Hold Music, Hot Line and Do Not

Disturb services.

The Basic Services page consists of two frames. The left frame lists all services. When you click on a service, its corresponding settings will be

displayed in the right frame.

Please Note: Remember to save changes before moving between the service configuration pages.

General Settings

The General Settings page consists of the following

components:

No answer timeout lists the possible timeout values for the

incoming call ringing duration before the voice mail system

answers.

Fig. III-34 Basic Services – General Settings page

Call Waiting

Call Waiting is used to receive an incoming call when you are currently on a call. The caller will hear a ringing tone and the Quadro user will hear a

special beeping on the telephone when the call arrives. To switch between the current call and the new incoming call, use the appropriate calling

code.

Enable Call Waiting Service activates this service and makes it available for the phone handset.

Auto Redial

The Autoredial service of Quadro supports automatic redialing if the called destination is currently busy or unavailable.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Comments to this Manuals

No comments

Quadro SW-Version 4.1.x User's Guide Page 36

Comments to this Manuals